|
Mfr.
O.M.C.
|
$144.12
-
$190.00
|
Above is the price you will be charged if you purchase this item(s). We do not show this price on the advertised page
because your price is below the manufacturer's suggested advertised price.
|
Products: 1 - 1 of 1
|
Page:
1
|
Post a question or comment about Tilt and Trim Pumps & Motors to our online boating community.
Power Trim Burned out
I have a 1987 Sea Ray 19 foot Sorrento. 4.3 V6.
I need a new pump. Which one is going to fit? Submitted by: numbered01
Power trim issues
I have a 1990 searay 16ft with a inline 4, the motor will not trim up or down. I can here the motor running but nothing is happening. I have looked and found no leaks. The new boat owner needs to now what needs to replace. thanks Submitted by: bullshooter
tilt motor
I have a 888 mercrusier need a new tilt motor it is a 2 wire which motor do I need? Thanks for the help Submitted by: Paul
Broken
My CMC 7050 failed yesterday. Boat is still in the water till this evening, so I haven’t had an opportunity to inspect. Tilt just dropped down and now swings free, actuator makes the same noise up/down as before. Is there a shear pin that could have failed or is it likely something more drastic? Submitted by: Greg
There is a pin. Pull the tilt motor and you will find a pin as well as a set of couplers.
Trim motor
Trim motor will not lower the drive. Can hear a "click" when the down switch is hit. Motor runs when the trailer switch is hit.
5.7 merc with alpha one. Submitted by: jd
If the motor goes up but not down, change the solenoid with the green wire. This should do the trick!
Show older >>
Thank you for submitting your review. Submissions are typically posted within 2 business days, pending approval.
Thank you for your submission. Most questions and comments are typically posted with a response within 2 business days.
|
|
|
