Post a question or comment about Steering - Mechanical Parts to our online boating community.
Hi I just bought a 16 ft steering cable for my boat a teleflex Ssc13416 unfortunately I didnt know it wouldn’t work with my helm. What helm do I need and do you stock it?
Submitted by: matt
Second Station for single Mercury Outboard
I would like to add a second control station to our boat with a single mercury outboard. Our control is currently p/n 883711 A12. Can I add another dual control or would I be better to go with a two lever single function at both stations?
Submitted by: Steven
You will need to change out both controls and all new cables. The engien controls will need to be single funtion and be compatible with a dual station set up. The link below will help you get started.
Sierra CH5400 Twin SR Engine Control
Can I get the shaft that the steering wheel goes on?
Can I get the shaft that the steering wheel goes on? Mine is pitted and needs replacement. The unit still functions verry well.
Submitted by: dave
You will need to replace the complete helm unit.
OMC Steering - 1973
Hi there, I need to replace the steering cable on my 1973 Seabird V24, with an OMC Sterndrive 225. The cable goes through the transom via a ball, and clamps onto the outside of the outdrive. I have a picture of the steering set up I can send you if that will help. Do you have this in stock? Many thanks, -Tom
Submitted by: Hottub Tom
You will need to remove the complete system. All you use over is the clam shells to hold the ball. You get a new cable, helm unit, ball kit and steering wheel. Once you have removed the system you can measure the cable.
Gasket repair kit for my Baystar hydraulic steering system?
I have a leak on the port side of my Baystar hydraulic steering system. Where the ram comes out from the black housing. Do you sell the repair gaskets for them, teleflex says its HP5607(portside)
Submitted by: billy
Show older >>