Ask. Answer. Discuss...Post a question or comment about Gauges.
|
Mfr.
Racor
| Mfr No. RK20726
Water Detection Gauge. 2" Gauge Water Detection Module. Light and Audio alarms
|
$136.56
|
|
Mfr.
Racor
| Mfr No. RK11-1669
Vacuum Gauge Kit, Replaces T-Handle, RK11-1669. Kit replaces original T-handle and includes gauge and lid fitting with o-ring. Silicone dampened gauge 0-30 in Hg....
|
$137.14
|
Above is the price you will be charged if you purchase this item(s). We do not show this price on the advertised page
because your price is below the manufacturer's suggested advertised price.
|
Products: 1 - 2 of 2
|
Page:
1
|
Post a question or comment about Gauges to our online boating community.
What Gauges can I use for my Engine?
I am replacing the dashboard and guages on a 1987 Four Winns 215 Sundowner and need to know what guage set would take the data from the original gasoline engine, fuel tank and outdrive. The engine is a six cylinder 195 HP carburated Mercruiser with an Alpha 1 drive. Submitted by: Mark
We do not have exclusive gauge packages for a Mercruiser however Teleflex gauges are acceptable for the senders on that engine, you will need to pick the Gauge Series that best suits your needs.
gauge cluster
I am looking for the whole gauge cluster (temp,speed,rpm,volts,trim,depth) for a 1994 Four Winns
hull # 4WNMC186G394
I beleive this was made by OMC would like complete goes in the dash
can you help Submitted by: Steve Lawrence
Hello, the exact gauges used in 1994 are no longer available. You will need to pick out a new design the suits your taste.
Gauges - changing the face
My instrument panel on my boat (gauges) work fine but would like to spruce them up and by just the back grounds. Can these backgrounds be purchased. Thanks for any info Submitted by: alan
You can try contacting the gauge manufacturer for that type of item but I highly doubt that is something they can supply; typically, they are NOT consumer serviceable at all.
Temperature guage
I just bought your equal to the Merc 12415 & want a matching temperature gauge to go with it. Do you have a gauge that will match up to this sender? Submitted by: marc
You will need to pick out what Gauge Series is the closest to what you have.
gauge replacement
I have a 1999 maxum 1900sr. Maxum is out of business and I am looking for some replacement gauages, specificaly a tachometer. I can’t find any that will fit in the existing dash holes. They are faria, but an odd size and no one seems to sell them anymore. I believe the Faria tach# was/is TC9456. Do you have some that will fit in the existing hole cutouts? Submitted by: ryan
We have standard round 3 inch Tachometers available, you may need to alter your dash pod.
Show older >>
Thank you for submitting your review. Submissions are typically posted within 2 business days, pending approval.
Thank you for your submission. Most questions and comments are typically posted with a response within 2 business days.
|
|
|
