|
|
|
Mfr.
Jabsco ITT Marine and Industrial Pumps
Jabsco, Inline Waste Evacuation Pump, Diaphragm, 50890 Series. Flexible installation, no filter required...
|
$225.75
-
$234.29
|
|
Mfr.
Jabsco ITT Marine and Industrial Pumps
Jabsco, Macerator, Sealed, Self-Priming, 18590 Series. Jabsco nitrile compound impeller, stainless steel cutter reduces particle size to 1/8" (3mm) maximum...
|
$156.99
-
$171.08
|
|
Mfr.
Jabsco ITT Marine and Industrial Pumps
| Mfr No. 18690-0000
Jabsco, Self-Priming 115 V AC Heavy Duty Macerator Pump, 18690 Series. The ideal answer to waste handling problems for marine, recreational vehicle and domestic uses...
|
$651.69
|
|
Mfr.
Whale Water Systems
| Mfr No. BP0527 Bulkhead
Manual Sanitation Bilge Pump for use either as a sanitation pump or a bilge pump. This pump has the ability to digest quite a bit of debris without problems...
|
$144.81
|
|
Mfr.
Jabsco ITT Marine and Industrial Pumps
| Mfr No. 18593-1000
Replacement Parts Sold as Single Pieces Unless Otherwise Noted
|
$36.27
|
|
Mfr.
Jabsco ITT Marine and Industrial Pumps
| Mfr No. 17246-0000
Jabsco, Electric Motor, 12v Volts, 17246-0000...
|
$165.35
|
|
|
Mfr.
Jabsco ITT Marine and Industrial Pumps
| Mfr No. 18594-1000
Jabsco, Macerator Pump Housing...
|
$42.07
|
|
Mfr.
Johnson Pump
Viking Power 32 Vacuum Pump, 8.5 GPM, 12 & 24V (volt), Single Diaphragm, 1 1/2"...
|
$259.64
-
$266.58
|
|
Mfr.
Raritan
| Mfr No. PST1203
Purasan Waste Treatment Device (Pressurized Water)
|
$1,259.69
|
|
Mfr.
Thetford
Discharge Pump & Macerator for Tecma...
|
$368.97
-
$368.97
|
Above is the price you will be charged if you purchase this item(s). We do not show this price on the advertised page
because your price is below the manufacturer's suggested advertised price.
|
Products: 1 - 10 of 10
|
Page:
1
|
Post a question or comment about Macerator & Waste Pumps to our online boating community.
Marine Compact Electric Heads
I have the Marine Compact Electric Heads. When pumping, it recirculates the bowl water instead of out. Valves open, hoses clear, joker valve OK, seems assembled properly, impeller good. With Y-valve either position it just won’t pump out possibly? Submitted by: Jim S
So here is what to check in order (I know that you have said yes to most of these);
Are the valves all open?
Does the bowl fill?
Can you hear the pump run when (trying to) emptying?
Set to pump into tank?
Tank not full?
Tank venting?
and - there is nothing clogging it?
If you close the intake and operate the flush does it pump out then?
What was the last couple things you did to the toilet? Was it just a seasonal sitting or were you doing repairs?
plumbing question
On my wellcraft, 1.5" sanitation hose comes to the macerator. There is also std sanitation hose leading to the overboard fitting, inside at the macerator nipple end was a coaxial 4" of hose to upsize the 1" discharge fitting to the sanitation hose, but is difficult to find. Suggestions. Submitted by: doug
We have a wide variety of plumbing fittings which you can combine in many different ways to reduce or increase from 1.5" to 1" and vice-versa.
We also carry Sanitation Hose.
Thank you for submitting your review. Submissions are typically posted within 2 business days, pending approval.
Thank you for your submission. Most questions and comments are typically posted with a response within 2 business days.
|
|
|
