Free Shipping on Orders $99+
Contact Us
Orders Product Guides
Boat Parts Worldwide

Stern Bearings and Struts

Products: 1 - 3 of 3
Rubber Sleeve Stern Bearings - Naval Brass

Rubber Sleeve Stern Bearings - Naval Brass

Mfr. Duramax Marine

Full molded type. Duramax rubber-lined Naval Brass Sleeve Bearings adapt equally well to strut and stern-tube mounts and are often used effectively as rudder-st...
$47.23 - $357.95

View Details
Rubber Sleeve Stern Bearings - Non-Metallic

Rubber Sleeve Stern Bearings - Non-Metallic

Mfr. Duramax Marine

Full molded type. Non-metallic. Bearings feature a dense structure of engineered reinforced thermoset plastic. The specially compounded Nitrile Ru...
$38.85 - $161.76

View Details
Brass Marine Bearings for Shafts

Brass Marine Bearings for Shafts

Mfr. Morse Marine Bearings

Pollution-Free Naval Brass Marine Bearings to protect your boat and the water she plies. Clean brass sleeve with oil resistant rubber shaft cushions shaft, installs in minutes, lasts for years...
Sale Price From $46.62

View Details
Products: 1 - 3 of 3
Page:  1

Ask. Answer. Discuss.
Post a question or comment about Stern Bearings and Struts to our online boating community.
Question
Samrock boat parts

samrock 246 adventure 2005
engine yanmar 4LHA-STP n° 56431

The shaft is 1-1/4
we need this replacement part:
83320 870322101
we think it’s correct but we’d like you to check compatibility.
We also need the adjustable packing seal, can you find the correct one?

Submitted by: Sergio
Answer

If the OD of the old Bearing is 1-3/4", this is correct. You have a dripless shaft seal installed in your boat. Do you need a replacement internal seal or the complete unit?


Question
Can I get a new strut for 1980 Ski Nautique?

My strut isnt too bad and I can probably straighten it if I remove it from the boat. I have press brakes at my disposal. However I would like to know the price for a new shaft strut and bearing. My boat is an older Ski Nautique with a 13 13 prop.

Submitted by: bill pryor
Answer

For a boat that old, we will need the casting number from the existing strut. It should be a single letter and two numbers and might be "S19". We also need to confirm the size of the shaft.


 
Name / Nickname:

Email:
(optional)


Type of Submission:

Subject:

Message:
Tips on Reviewing:
  • How you use the product
  • What you like about this product
  • How can this product be improved
  • When asking about Engine Parts, please include: Year, Make, Model and Serial Number of engine or part

Please do not include: personal information, profanity or copyrighted works. Conditions of Use