|
Mfr.
Duramax Marine
Full molded type. Duramax rubber-lined Naval Brass Sleeve Bearings adapt equally well to strut and stern-tube mounts and are often used effectively as rudder-st...
|
$56.44
-
$280.93
|
|
Mfr.
Duramax Marine
Full molded type. Non-metallic. Bearings feature a dense structure of engineered reinforced thermoset plastic. The specially compounded Nitrile Ru...
|
$41.31
-
$178.94
|
|
Mfr.
JIB Bearings
| Mfr No. UCFX0824
Radial Flange Bearing, 4 Bolt 1-1/2" w/ Set Screws, for 1 1/2" shaft...
|
Request Availability
|
|
Mfr.
Morse Marine Bearings
Pollution-Free Naval Brass Marine Bearings. Brass sleeve with rubber oil resistant shaft. The clean bearing that cushions the shaft, installs in minutes and lasts for years
|
$90.25
-
$281.04
|
Above is the price you will be charged if you purchase this item(s). We do not show this price on the advertised page
because your price is below the manufacturer's suggested advertised price.
|
Products: 1 - 4 of 4
|
Page:
1
|
Post a question or comment about Stern Bearings & Struts to our online boating community.
Samrock boat parts
samrock 246 adventure 2005
engine yanmar 4LHA-STP n° 56431 The shaft is 1-1/4
we need this replacement part:
83320 870322101
we think it’s correct but we’d like you to check compatibility.
We also need the adjustable packing seal, can you find the correct one? Submitted by: Sergio
If the OD of the old Bearing is 1-3/4", this is correct. You have a dripless shaft seal installed in your boat. Do you need a replacement internal seal or the complete unit?
Can I get a new strut for 1980 Ski Nautique?
My strut isnt too bad and I can probably straighten it if I remove it from the boat. I have press brakes at my disposal. However I would like to know the price for a new shaft strut and bearing. My boat is an older Ski Nautique with a 13 13 prop. Submitted by: bill pryor
For a boat that old, we will need the casting number from the existing strut. It should be a single letter and two numbers and might be "S19". We also need to confirm the size of the shaft.
Thank you for submitting your review. Submissions are typically posted within 2 business days, pending approval.
Thank you for your submission. Most questions and comments are typically posted with a response within 2 business days.
|
|
|
