|
Mfr.
Sierra
| Mfr No. 18-9750-0
- Formulated for high operating pressure
- Anti-foam additives assure uniform flow with reduced air contamination in hydraulic systems
- Designed for
...
|
$6.50
|
|
Mfr.
Sierra
| Mfr No. ARC M525
- Replaces Merc# 18525A1
- Replaces Aqua Power# 2414
- Sierra #18-6771 Discontiued, replaced by Arco# ARC-M525
|
$37.38
|
|
Mfr.
Sierra
- For all Power Trim Equipped, Inline engines except models with the power trim pump mounted between the engine clamp brackets
- Small diameter (1/8" I.D.)
...
|
$42.26
-
$46.62
|
Above is the price you will be charged if you purchase this item(s). We do not show this price on the advertised page
because your price is below the manufacturer's suggested advertised price.
|
Products: 1 - 3 of 3
|
Page:
1
|
Post a question or comment about Tilt and Trim System Parts to our online boating community.
tilt and trim issues on a 200 EFI Mercury
The tilt and trim just started making a rough grinding noise. It kinda reminds you of a rotary hammer drill noise. The tilt and trim continues to go up and down without the noise changing. I am trying to also figure out the year of the motor and tilt. It is a 200 Merc EFI. Mercury 200 HP
XRi
Electronic fuel injection Serial # oC261267 Submitted by: jeff melton
Power Trim & Tilt Motor & wiring
I have a 1991 Mercury 175XRI outboard motor that the power tilt & trim motor and wiring harness that is completely burned (meltdown). What replacement motor & wiring harness do I need? Motor model # 1-175413L and Serial # ODO68654. Thanks. Submitted by: Tony
Tilt n Trim
My tilt only clicks the solenoid when I try to lift it or put it down. Its a 91 100 hp Merc. Where should I start looking for problems? Submitted by: Skippy
Try putting power directly the the tilt motor and see if runs. The blue wire is up and the green wire is down!
stern drive tilt and trim pump
My stern drive goes all the way down but would only go half way up and then the pump quits then stops making noise. Submitted by: Roly
Sounds like you need a new trim/tilt motor. What is the make model and year of the engine/drive package?
CMC - model 7050
CMC motor model 7050 wires burned up. Think I Need new motor. Got any ideal? Submitted by: Vic
Please contact CMC directly for a new motor.
Show older >>
Thank you for submitting your review. Submissions are typically posted within 2 business days, pending approval.
Thank you for your submission. Most questions and comments are typically posted with a response within 2 business days.
|
|
|
