Motor: Permanent magnet, double ball bearing armature, electronic speed control built into rear endball
CSA Listed / EN ISO 8846 Marine / C.E. Certified
Protected under U.S. Patent #6,607,360
Mount the pump in a dry, ventilated location. The inlet strainer must be installed between the fresh water supply and the pump inlet port. The supply tank should be at least half full prior to initial operation.
NOTE: The VSD electronics require a battery installed in the DC power supply when using an AC to DC converter or battery charging system.
IMPORTANT: Polarity of electrical connections is very important. Insure that the RED () motor lead is connected to a fused positive DC circuit. The BLACK (-) motor lead must be connected to the negative DC circuit. In the event that polarity is reversed, in-line fuse must be replaced.To prime the plumbing system, open all the faucets and turn on the power to the pump. Shut off each faucet as it begins to run free of air. As the last faucet is closed the pump will slow down and shut off.
Thank you for submitting your review. Submissions are typically posted within 2 business days, pending approval.
Thank you for your submission. Most questions and comments are typically posted with a response within 2 business days.
Submit a review and you will automatically be entered into our monthly drawing.
Winners will receive a $25 Gift Certificate good at Go2marine.com. Make sure to enter in your email address so that we can contact you. Winners will be announced on our Twitter & Facebook Page.
(We keep your email address private.)
Mon. - Fri. 6AM to 5PM, Pacific Time Contact Us About Us