Description
3,000 Joules Surge Protection Module
This replacement surge protection module is only for the PWD30-EPO and PWD30-EPO-H units. It is designed for use only with the auto shutoff versions.
Simple installation! The only tool required is a Phillips screw driver.
Instructions
- UNPLUG THE UNIT – make sure unit is fully disconnected from power prior to installation.
- Unscrew 8 Phillips screws on the back of the unit.
- Unscrew the top and bottom cable gland nuts.
- Unscrew the screws holding the old surge module.
- Unplug the old surge module from the unit.
- Connect the new surge protection module.
- Replace all the screws and re-tighten the cable gland nuts.
CAUTION!
Make sure unit is unplugged before installation!
This replacement surge protection module is only for the PWD30-EPO and PWD30-EPO-H units. It is designed for use only with the auto shutoff versions.
Additional Information
WARNING: This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, visit P65Warnings.ca.gov